Lamp on and display

Zoom is [Format] & [Wheel]
On ETCnomad, Format is F4 and the wheel is your mousewheel.

See the built-in Help for details - F1 to open, then search.

VariLite fixtures don't activate the command until you do Lamp Idle, so the order is "Lamp On" ... wait few seconds ... "Idle"

Hi thank you for reply.
but where I find lamp on /lamp idle /enable on Nomad version?

The softkeys are on the right-hand side of Screen 1.

Device Lamp Controls are under Device > Lamp Control

But there is no soft key for "enable". Just Lamp on, lamp off lamp Idle and reset.
On the console you also need to hold "Enable"...

Onscreen softkeys do not need to be held down, because you've only got one mouse pointer.

Just click the softkey (or touch it if you have a touchscreen)

Ok Thank Richard
so just DEVICE>LAMP CONTROL>LAMP ON.

to turn off > LAMP OFF

nothing else that try and try it again until it start. Right?

Best!

Vari*Lite fixtures are a little odd, as they wait until you send the Idle before they do the lamp control command.

In general I'd suggest using
Device > Lamp Controls > Lamp On or Lamp Off
wait a few seconds
Device > Lamp Controls > Idle

That covers most fixtures (those that don't actually have an Idle will just ignore it)

I'm guessing Varilite did it that way so you have a chance to re-select Lamp On if you hit Lamp Off by mistake.

Vari*Lite fixtures are a little odd, as they wait until you send the Idle before they do the lamp control command.

In general I'd suggest using
Device > Lamp Controls > Lamp On or Lamp Off
wait a few seconds
Device > Lamp Controls > Idle

That covers most fixtures (those that don't actually have an Idle will just ignore it)

I'm guessing Varilite did it that way so you have a chance to re-select Lamp On if you hit Lamp Off by mistake.