ETC CS20 - after pulling down (switching off) the playback fader and switching to manual mode the cue remains running

Hi there! 

I have a problem with CS20. 

I record a scene to a playback fader (doesn't matter which physical fader). 

Then I return all fixtures to home position. 

Then I go to playback mode and pull up the fader - the scenes run as should. 

Then I pull down the fader with playback - the fixtures dim out but moving heads continue to move in dark. 

I switch to channel mode, choose any fixture, move any fader up - but fader continues to function as a playback fader outputting the same data I recorded into the scene. 

Then I open fixtures parameters from the screen - I see that data is the same as I recorded into the scene. 

Then I once again press Home - the fixture returns to home position. 

Then I pull the fader down completely. 

Then I pull the fader up - only then the fixture starts to work in manual mode. 

Please tell me what to do to switch off the playback completely before going to manual mode. 

Parents Reply Children
No Data
Related