Sound 2 light and magic sheet

Hi I try to trigger the MUTE button or sound2light via a magic sheet in Eos. So i don't have to change programs to mute, and also the mute keys are very small in S2L.

So I get s2l to send messages to Eos - piece of cake, just put in the correct IP address and the light moves to the music.

There is an example of a magic sheet in an eos file, it sais in the manual of sound 2 light - but I cannot find this showfile anywhere to check out how it is compiled. It is only a screenshot, nothing else.

I tried to make buttons in the magic sheet, and giving these commands, copy paste the supported osc message as is given in the s2l manual. This doesn't do anything.

Anybody who can give me some more advice about this? or an example?

Do I have to change things in the Eos - settings? Or am i going about this the wrong way completely?

thanks!!!

Parents

0 ueliriegg over 5 years ago

couple of things to check:

Setup>System>ShowControl>OSC: OSC TX IP Address: set it to the IP of your S2L computer
in the same spot also make sure that the TX Port is correct

check the firewall of your S2L computer, they can be a one way street

in magic sheet did you create an object, set it to Command and entered one of the OSC syntaxes into the Command box? which command did you use?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Anne over 5 years ago in reply to ueliriegg

thanks for your answer. Good to hear im on the right track. I will let you know later if I figure it out. The osc message I use in the command box is for example

/s2l/high/mute=0
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Anne over 5 years ago in reply to ueliriegg

thanks for your answer. Good to hear im on the right track. I will let you know later if I figure it out. The osc message I use in the command box is for example

/s2l/high/mute=0
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Anne over 5 years ago in reply to Anne

Hi I tried again - not working. But i'm trying it between running both s2l and eos on one mac. So you can just go from s2l (or luminosus) to eos on the normal wifi network on the same computer. Maybe doesn't work the other way around. Also with OSC from Qlab to eos it did not work unless i put a router in between. Hopefully this is the issue. I try again tomorrow or the day after.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel