when you say "time set" which time do you refer to? to the cue time? that's on purpose. GoToCue uses a default time from setup (setup, desk, manual control, GoToCue Time). if you want to use cue timing type GoToCue # Time Enter, this will take the cue time. if you want to take another time, use GoToCue # Time 8 Enter.
console in cue 0 , if i jump to cue 8 cue 8 has a up and down time of 3 but when you go to cue 8 enter they pop on with no time. If I then go go to cue 9 enter cue 9 pop with no time. I know i can do go to cue 9 time 3 and that will work, but should the board use the Cue list timing when you GO TO CUE #
Show setting cue setting all set to 3
Desk Settings manual control all times are set to 3..
No, the console should not take cue timing when GotoCue is used. It should and does use GotoCue timing.
Manual timing is used when you add manual values to a parameter (stuff written in red).
You were almost in the right spot for GotoCue time. Look further to the right, there is a box that says "GoTo Cue Time".
By the way default for that time is 5, someone seems to have changed it to 0 in your showfile...
No, the console should not take cue timing when GotoCue is used. It should and does use GotoCue timing.
Manual timing is used when you add manual values to a parameter (stuff written in red).
You were almost in the right spot for GotoCue time. Look further to the right, there is a box that says "GoTo Cue Time".
By the way default for that time is 5, someone seems to have changed it to 0 in your showfile...