Gateway Net 3 patching

Their are a stack of very good tutorials on youtube that will walk you through it.

 

It is critical (unless you have RDM) that you know what universe the gateway is set to output. Look at the screen, if it has one.

When in doubt grab the manual for the exact version you have. The Ion tutorials are strongly recommended! I particularly like the "Tea Break Tutorials" more than the videos. Both is best!

Do you know what section to look in the manual?

The videos are best found via the main ETC site, but they are all on YouTube.

The Ion manual has a chapter on basic patching and another on patching movers and LEDs.

https://www.etcconnect.com/Products/Consoles/Eos-Family/Ion/Documentation.aspx

There are several gateway manuals and you might even want to get into 'Concert' which is software for configuring gateways and other stuff. I think you have a lot of reading to do. But this is great place to ask questions, I'm sure some will surface.

www.etcconnect.com/.../

The videos are best found via the main ETC site, but they are all on YouTube.

The Ion manual has a chapter on basic patching and another on patching movers and LEDs.

https://www.etcconnect.com/Products/Consoles/Eos-Family/Ion/Documentation.aspx

There are several gateway manuals and you might even want to get into 'Concert' which is software for configuring gateways and other stuff. I think you have a lot of reading to do. But this is great place to ask questions, I'm sure some will surface.

www.etcconnect.com/.../