CD80 dimmer pack with MicroVision

I'm trying to connect an old analogue CD80 dimmer pack to my MicroVision FX for a show in a converted garage. The manual says it's possible to convert the 4pin output to do this and I have the capability to solder the right connections. What do I do? Anyone have suggestions for resources on this?

Parents
No Data
Reply
  • From the mind of Mr. David North:

    Depending on when the CD-80 was made, it might use a 4-pin XLR, in which case the cable is 1-1.  However, if it is an older CD-80 pack, with a TA4, then you need the following:

     

     

    XLR Pin

    TA4 Pin

    Signal

    Belden 9723

    Belden 9156

    4

    1

    Clock -

    Green

    Black

    2

    3

    Clock+

    White

    White

    1

    2

    Common

    Black

    Black

    3

    4

    Analog

    Red

    Red

     

    Found here:  http://www.pathwayconnect.com/content/view/92/26/

     

    But if your CD-80 pack is analog, as in 0-10vdc, then you need an analog output card [36-pin Centronics on rear panel]


Children
No Data
Related