Default vs Offset

[QUOTE=JayJay;68675]Page 122 says yes.

So default values affect preprogrammed values as well?

Well, I guess there is the difference..

The Default values should be absolute values only. They should only set a default value. Any programming of values ontop of the defaults will result in another absolute value overiding the defaults.

When I get done with the HoneyDoo list, I'll have a go at playing with offsets. I will guess that the offset will add or subtract parameter values from both the default value and any other programmed values.. Example, Default for fixture 1 is +90tilt and Cue 1 sets that tilt value at +100 tilt. Without an offset, you will get +90tilt when all fixtures are released and nothing in the programmer. Then by running Cue 1 you should get an absolute value of +100tilt. Now add a +5tilt offset and release the fixture and I am guessing you will get an output tilt value of +95. Then run cue 1 and again I am guessing you will get an output tilt value of +105.

If this is the case, then the offset value will adjust all the values (default and programmed) in a show file globally.

So, in your example in your original post... Set default values for your first rig. Then in the subsequent shows on the same rig, if you find the Truss trim or position is slightly off and focus positions don't match, but a simple +3 degrees of pan will get everything closer, then set your offset to pan +3 degrees.

The above is just my assumption, as I haven't messed with offset yet.

JB

[QUOTE=JayJay;68675]Page 122 says yes.

So default values affect preprogrammed values as well?

Well, I guess there is the difference..

The Default values should be absolute values only. They should only set a default value. Any programming of values ontop of the defaults will result in another absolute value overiding the defaults.

When I get done with the HoneyDoo list, I'll have a go at playing with offsets. I will guess that the offset will add or subtract parameter values from both the default value and any other programmed values.. Example, Default for fixture 1 is +90tilt and Cue 1 sets that tilt value at +100 tilt. Without an offset, you will get +90tilt when all fixtures are released and nothing in the programmer. Then by running Cue 1 you should get an absolute value of +100tilt. Now add a +5tilt offset and release the fixture and I am guessing you will get an output tilt value of +95. Then run cue 1 and again I am guessing you will get an output tilt value of +105.

If this is the case, then the offset value will adjust all the values (default and programmed) in a show file globally.

So, in your example in your original post... Set default values for your first rig. Then in the subsequent shows on the same rig, if you find the Truss trim or position is slightly off and focus positions don't match, but a simple +3 degrees of pan will get everything closer, then set your offset to pan +3 degrees.

The above is just my assumption, as I haven't messed with offset yet.

JB