Options
Related

Obliged to downgrade !!!!! V2.0.1 is Urgent

Hi

I 've too many problems in V 2

- Merger
- Touch ans suck problem
- effects sometimes still running in programmer even if table in "OFF"
- preset loosed after updating in V 2
- No possibility of preset for begin and end in effect engine
- no begin & end for color wheel, gobos, ....
- result really strange with the new effect engine
- Network ( 2 desk on the same show ), choose selection is mirroring on the 2 desk....a real problem.



.......

I'm sur you know all those problems


I think it is urgent !!


BEST

SEBASTIEN
Parents
  • 0
    I looked into the Fx offest

    When you select your 6 units and fan the offset between 0-360 your offset is as follows:
    0 / 72 / 144 / 216 / 288 / 0

    When you fan your offset between 0-288 your offset is as follows:
    0 / 58 / 115 / 173 / 230 / 288

    You are actully fanning the offset between 0/288 not 0/360.
    In the case of an 0-360 offset the reason you only see 5 values on the encoder is because we dont show repeat vaules.
Reply
  • 0
    I looked into the Fx offest

    When you select your 6 units and fan the offset between 0-360 your offset is as follows:
    0 / 72 / 144 / 216 / 288 / 0

    When you fan your offset between 0-288 your offset is as follows:
    0 / 58 / 115 / 173 / 230 / 288

    You are actully fanning the offset between 0/288 not 0/360.
    In the case of an 0-360 offset the reason you only see 5 values on the encoder is because we dont show repeat vaules.
Children
No Data

www.etcconnect.com