Check to make sure the following... If both cue lists have the same parameters (ie: both cues only contain color for the same fixtures)...then sending a GO command on the second cue will release the first one.
I have run into this when trying to use a command key to "flash a color" on my entire rig. You need to make sure that the second cue you trigger does not have the same parameters in use as the first cue.
Example- cue A has only color values cue B has only color values cue C has color and beam values
If you trigger cue A...then trigger cue B...cue A will release. But, If you trigger cue C...then trigger cue B...cue C will not release
Check to make sure the following... If both cue lists have the same parameters (ie: both cues only contain color for the same fixtures)...then sending a GO command on the second cue will release the first one.
I have run into this when trying to use a command key to "flash a color" on my entire rig. You need to make sure that the second cue you trigger does not have the same parameters in use as the first cue.
Example- cue A has only color values cue B has only color values cue C has color and beam values
If you trigger cue A...then trigger cue B...cue A will release. But, If you trigger cue C...then trigger cue B...cue C will not release
