Spinning Prism? Probably a Simple Fix

I came across a cue that I did not create, where the gobo itself was not rotating, but it appears as if the 3 face prism is rotating. I like it, but cannot for the life of me figure out where to adjust it.

Any ideas where I can look?

Parents

0 flyingpigphotography - Former HES Forum Member over 11 years ago

I had always seen the Beam 1 of 2 and wondered how to find the other parameters. Hitting the Beam button again is what I needed.

Thanks for the advice about the videos. I had watched them earlier on, it was too early; perhaps now is the time.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 flyingpigphotography - Former HES Forum Member over 11 years ago

I had always seen the Beam 1 of 2 and wondered how to find the other parameters. Hitting the Beam button again is what I needed.

Thanks for the advice about the videos. I had watched them earlier on, it was too early; perhaps now is the time.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data