Options
Related

Copy troubles

Hi,
I will perform a training as trainer in the beginning of November so I revise my classics and more specifically the functions which I do not use every day. I found a trouble when I try to copy parameters from a fixture to an other with mask in a specific destination. I tried 3 commands:
Fixture 1 Thru 4 Copy 8 Thru 11, Enter
1 ) 1 Thru 4 Intensity Copy List 3 Cue 1 Fixture 8 Thru 11, Enter (the one that is in the manual page 157)
2 ) 1 Intensity Copy List 3 Cue 1 Fixture 8 Enter
3 ) List 1 Cue 2 fixture 1 Position Copy List 3 Cue 1 Fixture 5 Enter

Every times it's the fixture from source that is stored in the cue instead of the one of destination.
1 ) In Cue 1 of List 3 I have the fixtures 1 Thru 4 instead of 8 Thru 11
2 ) In Cue 1 of List 3 I have the fixture 1 of fixture 8
3 ) In Cue 2 of List 1 I have the fixture 1 instead of Fixture 5

Am I doing something wrong or is there a trouble in the software?

Thanks
Stephane
Parents
  • 0
    I just refer to a line of the page 173 of the manual : "Group 5 Colour 2 Copy Colour 3 Enter : copies fixtures that are in Colour Palette 2 and Group 5 into Colour Palette 3."
    I have tested tested your solution with Position 2 that have Pan & Tilt values for fixtures 1 thru 8 and the Group 4 (Fixtures 1 thru 4) .
    By command Line :
    Position 2 Group 4 copy Position 5 Enter working until Group. As soon as I enter the 4, Group 4 take place of Position 2 Group. So at the end it looks Like I copy the Group 4 in the Position 5 (Groupe 4 Copy Position 5) and I have an empty palette.
    By touchscreens with Guard actived:
    Position 2 Group 4 than Command Line become red
Reply
  • 0
    I just refer to a line of the page 173 of the manual : "Group 5 Colour 2 Copy Colour 3 Enter : copies fixtures that are in Colour Palette 2 and Group 5 into Colour Palette 3."
    I have tested tested your solution with Position 2 that have Pan & Tilt values for fixtures 1 thru 8 and the Group 4 (Fixtures 1 thru 4) .
    By command Line :
    Position 2 Group 4 copy Position 5 Enter working until Group. As soon as I enter the 4, Group 4 take place of Position 2 Group. So at the end it looks Like I copy the Group 4 in the Position 5 (Groupe 4 Copy Position 5) and I have an empty palette.
    By touchscreens with Guard actived:
    Position 2 Group 4 than Command Line become red
Children
No Data

www.etcconnect.com