Options
Related

Fan with Repeat & buddying

Hello,
I have a matrix of 64 PAR64, 8 lines of 8. They are numbered horizontally from left to right and top to bottom.
I select 1 thru Enter.
- If I use a Buddying of 8 with a Fan Centre and the wheel Offset, I have the same result as X thru 0 Thru X, horizontal lines from center to top and bottom
- If I use a repeat of 8 with a Fan Centre and the wheel Offset, I have vertical lines from center to left and right. But If I use X 0 thru Thru X (with Reapeat of 8) I have not the same result and I havent found a way to reproduce it wit a set option. Even with a repeat of 4.
What is my mistake?

Thanks
Stephane
Parents
  • 0
    Here's what I have logged:

    D-02046
    When using grouping in a fixture selection, the fanning of any value should fan within the repeat groups. This works with simple one part X't work with multi-part XX fanning.

    100% Repro:
    New Show
    Add and patch 64 desk channels
    1
    Set group to 8 repeats
    @ 0
    Open the output window and notice that the fanned values of 0

    Regression Info:
    Occurs on Hog 3 OS v3.2.6
Reply
  • 0
    Here's what I have logged:

    D-02046
    When using grouping in a fixture selection, the fanning of any value should fan within the repeat groups. This works with simple one part X't work with multi-part XX fanning.

    100% Repro:
    New Show
    Add and patch 64 desk channels
    1
    Set group to 8 repeats
    @ 0
    Open the output window and notice that the fanned values of 0

    Regression Info:
    Occurs on Hog 3 OS v3.2.6
Children
No Data

www.etcconnect.com