HOG4PC and Marting Show Designer - is that working?

Hi,

I am trying to connect the HOG4PC (without DMX Widget) to the Martin Show Designer.

Does anybody know if that is working in general? The HOG knows the manufactorer type MARTIN in the setup for the visualization but the Marting Software is not presented as a selectable visualizer.

With Light Converse I did not have any problems with that.

Can anybody help me in that?

Best regards,

Matthias

Parents

0 dkayser - Former HES Forum Member over 7 years ago

Yes, Martin is working. If you see it detected in the visualizer configuration and select it, then it will receive the data. The fact that it is detected indicates you are close and it is probably something on the Martin side that isn't configured correctly. The Visualizer setting related to Hog4 are now found in the Visualizer configuration, not on the PC that is running the visualizer. Section 29 in manual is helpful.

drk
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 dkayser - Former HES Forum Member over 7 years ago

Yes, Martin is working. If you see it detected in the visualizer configuration and select it, then it will receive the data. The fact that it is detected indicates you are close and it is probably something on the Martin side that isn't configured correctly. The Visualizer setting related to Hog4 are now found in the Visualizer configuration, not on the PC that is running the visualizer. Section 29 in manual is helpful.

drk
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data