Any help for this woud be appreciated. The on-line tutorials are all (as far as I can tell) specific to console use. Most of those instructions are general enough to easily figure out how to apply them to a PC, but this has me stumped. I'm also unable to get to the Plot section, but I think this is because I need a full size touchscreen. Fingers won't allow me to touch and hold three 1/4" square buttons simultaneously : (
You'll need to supply a bit more info. Are you trying to connect to a visualiser on the same PC as the Hog 4 instance? What's your network setup?
To get to plot view, hold "Open" and it will bring up a series of soft buttons at the bottom of the screen, "plots" is about 2/3 in from the left hand side
You'll need to supply a bit more info. Are you trying to connect to a visualiser on the same PC as the Hog 4 instance? What's your network setup?
To get to plot view, hold "Open" and it will bring up a series of soft buttons at the bottom of the screen, "plots" is about 2/3 in from the left hand side
