Any help for this woud be appreciated. The on-line tutorials are all (as far as I can tell) specific to console use. Most of those instructions are general enough to easily figure out how to apply them to a PC, but this has me stumped. I'm also unable to get to the Plot section, but I think this is because I need a full size touchscreen. Fingers won't allow me to touch and hold three 1/4" square buttons simultaneously : (
Yes, the Hog4 software does not have a built-in visualizer, there is the plot window which was mentioned above, the plot window is good for displaying intensity and color in a graphical layout. It can also be used for fixture selections and pixel mapping. It does not have 3D visualizer functionality.
That being said, all consoles we sell come with a visualizer included. If you purchased a console before January 1st, 2019 it should have come with a Light Converse dongle. And if the console was purchased from HES after January 1st, 2019 it would come with a Capture License
Yes, the Hog4 software does not have a built-in visualizer, there is the plot window which was mentioned above, the plot window is good for displaying intensity and color in a graphical layout. It can also be used for fixture selections and pixel mapping. It does not have 3D visualizer functionality.
That being said, all consoles we sell come with a visualizer included. If you purchased a console before January 1st, 2019 it should have come with a Light Converse dongle. And if the console was purchased from HES after January 1st, 2019 it would come with a Capture License
