• State Not Answered
  • Date
    Mark Petersen
  • Date
  • Replies 5 replies
  • Subscribers 19 subscribers
  • Views 1522 views
  • Users 0 members are here
Options
Related

Run Macro on Show Load

This was discussed a few years ago in another thread, but I don't see anything else more current, so I thought I'd ask. Is there really no way to run a specific macro as part of the show file load process? I see how to load one on boot, but this one needs to be run AFTER the show file loads, or at the end of the load process. IS there really still no way to do this? It seems like such a simple, basic thing I just can't believe there's no options / setting to do it. If I likely looked right at it while searching, feel free to tell me "hey dummy... You looked right at it here: ".
Thanks all!
-Mark
Parents
  • 0
    Startup Macros will only trigger once the show has fully loaded.

    Give Startup Macros a try as I believe they are what you are asking for as Startup Macros will only trigger once the show has fully loaded and all DP's are found. Startup Macros can trigger a list/scene, recall views, adjust fader positions ect


    example:
    in a show
    setup - preferences - misc tab
    set a startup macro of RV1 (recall view 1)
    log off the show
    launch back into the show
    once back in the show, the startup macro will trigger and the view will get recalled
Reply
  • 0
    Startup Macros will only trigger once the show has fully loaded.

    Give Startup Macros a try as I believe they are what you are asking for as Startup Macros will only trigger once the show has fully loaded and all DP's are found. Startup Macros can trigger a list/scene, recall views, adjust fader positions ect


    example:
    in a show
    setup - preferences - misc tab
    set a startup macro of RV1 (recall view 1)
    log off the show
    launch back into the show
    once back in the show, the startup macro will trigger and the view will get recalled
Children
No Data

www.etcconnect.com