Light Converse - HOG4PC with LightConverse Net-In

Hi,

I have a LightConverse Net-In Dongle and LC installed on one computer. I want to preprogram with another computer on HOG4PC. Is this configuration possible?
I tried to activate the visualiser stream, but I can't get any input to LC. I have installed the Connectivity Tool an the LC computer.

Thanks for your replies,

Roman

0 shrunkenned over 7 years ago

there are a few things to configure. Check the manual or the video www.youtube.com/watch?v=028tk2cX9yY
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 elecor - Former HES Forum Member over 7 years ago

Hi, I have also Net-In license dongle.
You can connect only via ArtNet with this dongle, so you need hardware to unlock ArtNet outputs if you are using Hog4PC.
That's the problem ((
So you don't need any visualiser settings in Hog... Just configure ArtNet (IPs, etc...)
You can't connect it like visualiser with this dongle
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel