First post here. Sorry in advance for anything wrong. I'm sure this is an easy question. I just got a Road Hog 4 and have some Chinese Beam 200/230 patched in. I'm running the Clay Paky Sharpy Beam Vector profile 20 channel mode. They pan and tilt perfect. However when I try to do almost anything else with them, it takes a solid 30 seconds to change. So if I were to move the intensity from 0-100%, it will slowly raise up over about 30 seconds. Same with changing gobos, frosting, colors, etc. Whats the best way to change this back to the speed I can manually move the wheels/fader? Thanks!
Hi, Best guess there is a timing channel that is not functioning correctly withing the fixture profile ? If you select the fixture and then select the beam function and then look for timing or speed is there a way to change the default speed or alter the speed and then see if the intensity fade time ls correct ?
Hi, Best guess there is a timing channel that is not functioning correctly withing the fixture profile ? If you select the fixture and then select the beam function and then look for timing or speed is there a way to change the default speed or alter the speed and then see if the intensity fade time ls correct ?
