New Smartbar 2 seems to be ignoring the DMX address

Hello,

  I have just purchased a Smartbar2 for our Church.  It has 6 positions.  It has 4 Pars connected.  Through the LED Menu I set the "Start" DMX address to 28.  It does not respond on channel 28 however, it responds on channel 1-6.  There are other lights also on these channels.  The DMX cable in use goes to this new bar, then on to an "old" Smartbar 4 position, that one is working fine.  I do not believe the cable is in question.  Also the cable was being used previously without issue.  I have looked at the manual that came with the bar, but it is the v1.43 manual and I notice that the directions do not quite match the display on the new bar.  I assume that I have over looked somethign obvious. 

Any pointers would be appreciated.

Pat O

Lighting Volunteer

Woodridge Community Church.

Parents Reply Children
No Data
Related