RS-232 issues

Hello,

Has anyone run into a problem with RS-232 not being received in the onboard MSC RS-232 port (not even being shown in the log under debug) after upgrading Mosaic from 1.11.5 to 2.0.2?

I upgraded a Mosaic the other day and now the Lutron to Mosaic RS-232 commands aren't being seen. Now granted we haven't confirmed Lutron is still sending them, but let's not point fingers just yet. :)

Everything else from the upgrade works.

Thanks,

David

Parents

tom mcguire over 7 years ago

Hi David,

This is a problem when going from V1 to V2 but to fix it you will need to set the Serial input to RS485 and upload your config.

Then switch it back to RS232 and upload again and it should start working.

If you were using RS485 then you need to the switch to 232 and then back to 485 again.

Tom
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
David W. over 7 years ago in reply to tom mcguire

I don't know who you are but you sir are a scholar and a gentleman. If we ever meet I'll buy the best damn ice cream sandwich money can buy. (An It's-it for those wondering).

Thank you!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Davefox over 7 years ago in reply to David W.

mmmmmmm It's-it. SOOOOOO tasty.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Davefox over 7 years ago in reply to David W.

mmmmmmm It's-it. SOOOOOO tasty.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data