I did not quite understand from the manual how the master and slave controllers work with each other.
For example: in the slave controller there is a trigger with the action of sending UDP. In this case, the slave controller does not have an ethernet bus in the properties. How does this action work?
Someone else just posted about this in the other thread.
Good day, jabadger . Your proposal to solve our trouble did not give a positive result, response messages from controllers continue to be sent in a large number. What else do you think can influence this?
Please send your config to aesupport at etcconnect dot com and we will take a look to see what the issue is. Have a great day!
Good day, ctprice! Sent a config file.
I have not seen the config yet....replace at with @ and dot with a . in the previous email address mentioned please.