Unison LCD screen calibration

I have a Unison LCD touch panel at the booth and the screen is off calibration. It turns out the glue holding the touch screen glass is wearing out and the screen has slipped down about half an inch off of the lcd part underneath. Is there a way to have this repaired or replaced?

Parents

Jake over 10 years ago

Unfortunately, there is no easy way to take apart a touch panel as there are no screws on the back, only rivets. I think you'll need to send that one back to the factory.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JLicklider over 10 years ago in reply to Jake

Thats what I figured. Thanks!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

JLicklider over 10 years ago in reply to Jake

Thats what I figured. Thanks!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Seth A Starr over 10 years ago in reply to JLicklider

99% this will result in a broken touch portion of the LCD and they will have to install a new one! While the glue/tape slips, the glass normally cracks before it releases...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel