How to bind control stations to the architectural processor ver 1.3 unison

I cant seem to get my button stations and lcd stations to bind to the arch processor in my racks. I went through the unison prompts on the cem and once i get to stations and press enter that's were it stops. It does not give me a list of un bond stations. Although when i go through the diagnostics it lists all 21 of my stations as unbound.

Thanks Terry

Parents

Tracy.Fitch over 9 years ago

Terry,
Have you tried resetting your CEM and the external station power supply (press the button in until it clicks) within 30 seconds?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Terry32130 over 9 years ago in reply to Tracy.Fitch

That worked thanks could you tell me if the addresses are labeled on the push button stations or the lcd stations ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Tracy.Fitch over 9 years ago in reply to Terry32130

There should be address labels on both. You will need to remove the faceplates from the stations and, depending, you might need to take the stations out and check the back side.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Tracy.Fitch over 9 years ago in reply to Terry32130

There should be address labels on both. You will need to remove the faceplates from the stations and, depending, you might need to take the stations out and check the back side.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data