Unison touchscreen system design

I'd like to use a Unison touchscreen on a small architectural installation that'll have 8 dmx dimmer channels (2 x ETC Smart-Bars) & 15 channels of dmx control for a couple of Martin Smartmacs. Documentation on the ETC website is a wee bit daunting and confusing....Is there an interface / controller that I also require in addition to the Unison Touchscreen?

Cheers!

Parents

Jeff Mabray over 14 years ago

You will need a processor of some type. In this case you will need a Paradigm processor to go along with the touch screen.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
mgarrison over 14 years ago in reply to Jeff Mabray

....and a rack to put it in (probably an ERn2), and some way to power the LCD (either PoE or a Paradigm Station Power Module in the ERn2 rack).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

mgarrison over 14 years ago in reply to Jeff Mabray

....and a rack to put it in (probably an ERn2), and some way to power the LCD (either PoE or a Paradigm Station Power Module in the ERn2 rack).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data