Control Unison system with Martin M1 Console

We have a guest LD bringing in his Martin M1 console and transfering our CAT5 feed from our Ion console to his M1 console doesn't work to control our system via the ECPB-DMX station at our FOH Booth. We have a show to do tonight... Any ideas?

Our system ETC Job number is 15006724 if that helps - but it is a DMX/ETCNet/Unison Control system

His Console is a Martin M1 and he has his Artnet Nod- Ether2DMX8.

Thanks,

Tim G.

ssteele over 12 years ago

Tim

It sounds like the best option is to come out of the m1 hard line dmx, I would first try using the dmx in the system, if that does not work you will need a dmx node or gateway to translate the data form dmx to either net 2 or net 3 depending on how your system is set up.

Thanks

Steve
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
tom mcguire over 12 years ago

If you have a show tonight then it would be best if you call your local tech support.

http://www.etcconnect.com/contact.aspx

It is very hard to fault find with posts on the forum.

Tom
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel