OSC network no input

Hi there

I have a Problem with osc Input in a nomad System.

I triggered cues via osc over the Network from a different Laptop. It Worked fine Till today. Both Computers are one the Same Network, can Ping each other, the osc command is sent direktly to the IP of the nomad PC but i reveice No Inputs in the diagnostic tab. Port seem fine, DMX Output works over sacn node, No Problem there. I have got two seperate devices triggering a Go. It Worked Yesterday, but today i can't figure Out whats the Problem. IS there any Chance the sacn node interfering with the Input? I Take any ideas for leads...

Thx!!

0 mathilda 8 days ago

Check on Both Computers if Send(TX) and Recive(RX) is Enabled.

Maybe i was Disabled for some Checking of something.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 glenben 8 days ago in reply to mathilda

Thx for the answer, i checked! It is quiete a mistery for me. I can access the pc, i see it in the network...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mathilda 8 days ago

What is the program you are try to trigger your ETC-Computer?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 glenben 8 days ago in reply to mathilda

One with ableton live, via grabbersender, just a go command (worked like a charm) and the other input ist a light switch with an ESP32 - both are on the same net, both worked before
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sstaub 8 days ago

Maybe you have a look with WireShark what happen on your network.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 glenben 8 days ago in reply to sstaub

Thx i'll try that, still got No Idea, Firewall Rules are set for the UDP ports, but nothing in the diagnostic tab
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel