Patching multiple devices on single channel

 Can I patch multiple devices (Color Source Par x 10) on single channel?  I know there was a similar question before, and the answer was YES.  But when I tried to do it in the version 3.1.1, the warning message was shown up.

" multiple devices on channel 1 : conflicts in red need to resolved".

I remember that the warning was not shown up in previous version.  Please give me an official answer.

Parents
  • 0

    No, this is not yet supported in ColorSource.
    It is "on the list" for a future version, as it would be useful to patch multiple fixtures of the same type to the same desk channel.

    At the moment ColorSource support patching multiple Dimmers and one Device to the same desk channel.
    However, in previous versions the warning was not always triggered, this has been corrected.

  • 0 in reply to Richard

    Hi Richard,
    Thanks for getting back to me. I’m still a bit confused about the following though:

    When I actually tried to patch multiple fixtures, although the error message displayed, I still got 10 CS Pars on one channel.
    I could control the fixtures as expected (both intensity and colour)

    Does this mean it is possible, but there may be bugs etc as it isn’t ‘officially’ supported?

Reply Children
Related

www.etcconnect.com