Updating/Recording Presets in Cobalt on Congo Jr.

Hello,

I have just installed the Cobalt operating system on my Congo Jr. and so far it is looking great!

I have run into a small problem though when recording and editing presets. In the Congo 6.4 and earlier software you could update/record a preset by setting lights and then typing the number of the preset and pressing record. This feature seems to not be available in the Cobalt software.

Thank you!

Ryan D. Barnes

Cornerstone Christian Fellowship

Chandler, AZ

0 rdbarnes73 over 10 years ago

Correction. It seems to be working but I have to tap "C/ALT" and "ESC" a few times before it will work.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Anders Ekvall over 10 years ago in reply to rdbarnes73

It sounds like you are doing some command before you use UPDATE that causes a button to be virtually stuck. Pressing ESC will unlock such a condition.

Could you tell us more about the commands you do right before UPDATE? Are you in some special state or tab when it happens?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 rdbarnes73 over 10 years ago in reply to Anders Ekvall

Fortunately it hasn't happened again. It seemed like it was happening if I was working in the direct select dock. Thanks.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel