Masters pages- automated faders

Hi,

Changing master page should not move the faders. Changing master page just loads new content to the same set of 20 master fields. If the faders are up, they are set to be pending, waiting for you to move the master down to 0% before switching content.

If you use SWAP or RANGE, you are changing which master field the physical fader controls. Then the motor faders will move to the current position of the new master field.

Anders,

How is with masters ranges and master pages. How it is work?

Page depends on range?

Range depends on Page?

Thanks  for quick replay :)

Anders,

How is with masters ranges and master pages. How it is work?

Page depends on range?

Range depends on Page?

Thanks  for quick replay :)

There are 4 blocks with a total of 80 master fields. All these fields are separate and can be active at the same time.

A master page just loads data to one block of 20 master fields.

Range connects the physical faders to one block of master fields. A Cobalt20 can connect the physical faders to master fields 1-20, 21-40, 41-60 or 61-80.

Think of it as a window of 20 faders that is sliding left/right over the set of 80 master fields, selecting which ones to control with the faders and buttons on the face panel.

Makes sense?

So I start default show, and I change a range on:

1-20  they have name - Page 1,

21-40 - they have name - Page2

31-40 - they have name - Page 3

41-60 - they have name- Page 4

label Page 4 i label of what? becouse if i load page 1 from seq step cobalt load deferent content

The label shows the page that is loaded to the master block you have connected your physical faders to.

Thanks.