Version 5

Hi all

Not wishing to be the harbinger of bad news but, I can't find where @ mode has gone? and ....

If you press the dynamic effect key followed by the insert key with no channels selected it causes a Congo application error message, don't think that happened in v4.3.

Happy days,

John

Ok, don't panic, I have found @ mode

Its in System settings under the general tab.

[edited by: Chuffer at 10:01 AM (GMT -6) on Sat, May 10 2008]

FloBaeumler over 16 years ago

Chuffer:
If you press the dynamic effect key followed by the insert key with no channels selected it causes a Congo application error message, don't think that happened in v4.3.
I just tried that, but I can't reproduce this. Can you reproduce the problem?
Florian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Chuffer over 16 years ago in reply to FloBaeumler

Hi Florian,
Strangely, I have just tried it again and all was well despite it doing it several times before I posted the message! Will try again tomorrow.
The Inhibits on the masters is good, lots of fun there but I don't think I will ever get used to RPN, a case of old dog, new tricks I'm afraid.
Best wishes
John
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Richard over 16 years ago in reply to Chuffer

"At Mode" is now a general setting for the console, rather than a per-show setting as it used to be.
Also, RFR and cRRFU remotes now support At Mode!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel