I built a moving light position chase, put it into sequence 2 and loaded that to a master, The effect worked properly. I then did a master link in my main sequence. The first two times I played the sequence, it worked properly. However after that the chase would start at the 3rd step instead of the first. If I brought the chase up manually on the master, it worked in the proper order. I never got it to run properly again , so I ended up running i9t manually. Any ideas as to what went wrong?
Hi, I always clear the chase of the master after it's been run when setting up. The chase will be auto loaded by the master link at the end of the step before it is used. This way you can always be sure that the chase will start from the begininng.
Hi, I always clear the chase of the master after it's been run when setting up. The chase will be auto loaded by the master link at the end of the step before it is used. This way you can always be sure that the chase will start from the begininng.
