2 port node problem

Hi Michal,

is this a Net2 Node, or a Net3 Gateway?

ETC Net2 DMX Node

I have 1 hour :)

ETC Net2 DMX Node

I have 1 hour :)

The problem is that the unit doesn't yet have an IP address.

You need ETC Net2 Configuration Editor (NCE) v4.3.0 from our website.

• Configure your PC for use on ETC networks (IP 10.101.1.x, subnet 255.255.0.0, Gateway 10.101.1.x)
• Start NCE, then in the menus choose Network > Connect.
• Then Network > Network Address Server
  • In the bottom-left, you should see "bootp server started"
  • If that doesn't appear, close NCE, run NicPicker and try again
• Now reboot the node.
  • It should show Bootp... then get an IP address of 10.101.50.x
• You can now choose Network > Get Unbound Nodes and configure it as normal.
  • Remember to use Network > Send Config to Nodes after configuring.

To use NicPicker:

• Open Windows Explorer, navigate to Program Files/ETC/NICPICKER
• Run the NICPICKER application.
• Select the correct network card to use for configuring the Node.
• Click "Save", accept the default save location.
  • It may warn you that you're overwriting, say yes.
• Close the NicPicker application - you are now ready to use NCE.

Note that all this assumes you're running Windows XP.

If you are running Windows Vista or Windows 7 then you will need to have installed the application as Administrator and always run it as Administrator.

Thanks a lot!

It helped :)