Auto Mark

Congo "AutoMark" always uses the timing from the place where the light actually comes on (Preset/Sequence Step).

So if you have an In time of 5 seconds when the light comes on, the 'marking move' before it will take 5 seconds.

If you change the Focus Time for the Preset where the light comes on to 2 seconds, then the 'marking move' for Pan & Tilt will take 2 seconds, while the Colour and Beam attributes will still take 5 seconds.

You can also use 'discrete' times for the specific attributes in the device if you need to be more specific - use [Format] & [Down_Arrow] in an Attribute Editor to show and edit these.

Congo "AutoMark" always uses the timing from the place where the light actually comes on (Preset/Sequence Step).

So if you have an In time of 5 seconds when the light comes on, the 'marking move' before it will take 5 seconds.

If you change the Focus Time for the Preset where the light comes on to 2 seconds, then the 'marking move' for Pan & Tilt will take 2 seconds, while the Colour and Beam attributes will still take 5 seconds.

You can also use 'discrete' times for the specific attributes in the device if you need to be more specific - use [Format] & [Down_Arrow] in an Attribute Editor to show and edit these.