Did I press something by Mistake ??

HI all, Congo Jnr running 6.04 with x-keys as remote,

Focused rig using remote, everything fine , went to the board, went into the output list changed a channel to "full at 1%" closed the list , selected 5 channels (to put into a master) moved the wheel channels went - M, 1, 2. couldnt do anything else with them, selected other channels with the same result.

I dont think I pressed anything else, I was in a hurry so rebooted - everything fine

Any Idea's ??????

Parents

0 Richard over 13 years ago

That doesn't half sound like an Inhibit Master or Inhibit Independent for those channels that's at 2% or so.

Do you remember what colour the levels were? If the level number (M,1,2 etc) was Red, then it was Inhibited somewhere.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Richard over 13 years ago

That doesn't half sound like an Inhibit Master or Inhibit Independent for those channels that's at 2% or so.

Do you remember what colour the levels were? If the level number (M,1,2 etc) was Red, then it was Inhibited somewhere.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 old man up north over 13 years ago in reply to Richard

I think the numbers were white, but I wouldnt bet my life on that, it was a fresh show with nothing in it , the first thing I did was what is described above I hadn't programmed anything in at all
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel