Q Lab Generic "Go".

Question

Is there a way to transmit a message from EOS over OSC that will result in QLab just pressing "go" on the next loaded cue, rather than a specific numbered one? I.E. a button on the EOS magic sheet that will just press "go" in QLAB?

sk8rs_dad · Answer

According to Figure53's documentation, if I'm reading it correctly, a generic Go is /workspace/{id}/go, where {id} is either the workspace name (MyCueList.cues) or the id displayed in the info tab of the status window (whatever that is). 
 This may be better asked on Figure53's forum. 
 Looking at the v4 docs it may also support a simple unqualified /go 
 http://figure53.com/docs/qlab/v4/control/using-osc-to-control-qlab/