Hello,
a few days ago i had a realy hard time with a GLP Bar10 in normal mode.(no MC mode)
No light would be outputted even though all intenses were at full.
- I only had 1 - 2 minutes. Than we changed over to compressed mode and than it worked out.
With the struggled in my head, i tryed again on Capture right now...
It's still not doing any output.
BUT!
If i use the 3Cell mode, it works (on Capture at least). The Job is done, so i can't research any more. Because i don't have the fixture at my hand...
What i can say is this:
The fixture in the Desk looks good. Checked it today. I also managed to use tilt and zoom at the job.
The only thing that wasn't working, was the intensity.
Maybe some other person can check again and figure something out.
Thanks
thilda
