A while back I was trying to program an effect onto one of my sub faders and have the next two faders control the rate of the effect. I was able to get the effect to work, but now I can not clear the effect on fader from the three faders. I have attempted to delete the subs programmed onto the faders, but that just deleted the sub, I still can not program anything else onto the three faders I used for the effect.
Any ideas of how to return these three faders to normal sub faders?
Thank you, this corrected my issue.
"Faders" on any of the EOS line consoles are encoders. They can be programmed to be almost anything. Unloading an encoder normally is just done by holding SHIFT and pressing BOTH BUMP BUTTONS. Have you tried this yet?
while there are plenty of ways (also faster ones) to do this, the central place for fader configuration is the fader config tab (Tab 36). everything that's related to faders can be done there. locate the first fader of the trio and click where it says S1 (S1 for Sub 1, for you of course the number could actually be different) and then choose "unmapped" and click "1x".