Is it possible to assign the wheel controlling channel to a midi controller ?
I don't find it in the midi table manual.
What is the control change for this wheel and other wheels (controlling devices) on cobalt ?
Maybe it doesn't exist ...
Thanks for help
bump! I want to know to!
Theoretically, it is possible but I am not sure how well a midi device would handle this.
First, Direct mode has to be switched off.
Controller messages 1-4 control parameter wheel 1-4. Controller message 5 controls the level wheel.
The controller value - 64 will be interpreted as a positive or negative wheel increment. Value 64 is 0, value 63 is -1, value 65 is +1 etc.
Would this work for you?
I didn't get it working at first try. but when I need to disable direct mode it's not worth it. Loosing 16 masters and 36 buttons over a level wheel. ;-)
but thanks for the answer.
Maybe OSC would be a better choice in this case. Level and parameter wheels are supported there.
yes. right now I'm on a KORG nanaKONTROL Studio and it do not do OSC. but it's good to know that it's there. I found this post while browsing the forums, and it was unanswered so I bumped it "just to get a answer". not real sure I need it! ;-)
Thank bumping and trying to answer !M
My question is not if it's possible to do it theoretically but if there is a midi code assign to this wheel in the cobalt software. Can't find it in the midi chart and i tried randomly to find it but no result.
I use OSC too but it would be great to use in midi code.
Hi, this is how it is implemented (but might not be very useful from the MIDI controller side):
"First, Direct mode has to be switched off.
The controller value - 64 will be interpreted as a positive or negative wheel increment. Value 64 is 0, value 63 is -1, value 65 is +1 etc."
sorry but i don't understand what you mean.
Anders Ekvall said:Controller messages 1-4 control parameter wheel 1-4. Controller message 5 controls the level wheel
first i need a midi code number for this wheel to use it, if the wheels are not assigned to midi in the software ican't control it !
MIDI message type is Controller (0xB0) followed by the wheel number (1-5). The third parameter is the wheel increment value as described above.
Thank you Anders for your time but it's very complicated for me with this wheel.
No problem to edit fader or button ... but this one ...
I don't undrstand the message type 0xB0. Wheel is not a control change and not a note.
I show you my screen capture of the korg jog wheel editor.
If you have time to help me . Thank you very much
Try to use the Inc/Dec mode. Set CW to 65 and CCW to 63. CC number is the controller number 1-5 depending on which wheel you want to control.
it works !!! thank you !!! i use it for the 5th wheel
the only thing is that increase is +48 % and decrease is ok (1% step by step)
any idea ?
Looking at your tool setup again, I am not sure if it can do this. The CC number needs to be 1-5 but the CC value should be 63 or 65. However, there is no way to enter the CC value as far as I can see.Is there anyone else in this forum that has experience of this tool and what is possible?
I try a lot of things but impossible to change this increase problem. Thank you very much for your time and advise !
I don't understand how to edit an independant with a control change with this korg software.
Note number is 126 and velocity is 99 or 100 or 101. But where do i insert the velocity value to control it ?