Can I recite timecode on Nomad from, for example , Q_LAB or SHOWKONTROL(like this) or TIMECODE sync? I am obliged to use shocwontrol gateway? there are others solutions?
I explain myself...
I would like use SHOWKONTROL (https://www.tc-supply.com) to receive timecode from CDJ's and after trigger cue on my nomad...
thank you in advance boys!
You will need a Net3 Show Control Gateway to receive Linear Timecode or MIDI Timecode. We also supply a response MIDI Gateway which only receives MIDI timecode.
MTC should possible with a simple MIDI Interface
i have had more than one simple USB-MIDI interface that couldn't do MTC, but of course wouldn't say so on the box. i assume the speed was too high. those interface are fine for midi notes and the like or MSC but not all of them actually do MTC...
The speed of the MIDI port is fixed to 31250bit/s and independent if you use MIDI, MTC, MSC, main problem is cheap hardware, bad cables, and ugly programmed software. So, OSC is the best way.
i use OSC usually, but this software not send OSC...
Maybe you try a simple USB Interface like ESI Midiface, around € 30.-
I try to look!
thank you friend!