Cant record cue

Question

I dont know what happend. Usually, when I want to change something, I just create the look I want and save that to a cue, expecting the console to keep track of wenn it is appropriate to save something. 
 So I have for example a cue 50 and a cue 40 and now I decide I need the same look of cue 50 in cue 30. That has been a [Goto Cue] 50 [Enter] [Record] [Cue] 30 [Enter] in the past - I'm pretty sure about that. 
 Now, somehow that Cue 30 is created, but when I leave it go back into it again, it seems like almost nothing has been saved into the cue and it doesnt look like before. What I can do is [Cue] 50 [Copy To] 30 [Enter]. That will give me a Cue 30 looking like the cue 50. But when I now decide I want Fixure 300 and 301 pointing to Ursa Minor and Fixure 305 in Blue, and I want to save that new Look into Cue 30, it wont happen. There is no Error-Message, it simply dont saves any changes. 
 I tried: 
 [Record][Cue] 30 [Enter] 
 [Record Only][Cue] 30 [Enter] 
 [Record][Cue] 30 [CueOnly] [Enter] 
 [Record Only][Cue] 30 [CueOnly] [Enter] 
 Console is in tracking mode, but I also tried the above in cue-only 
 V2.6.1.9.0.31

Mike A · Accepted Answer

You've not managed to accidentally turn on a record filter. 
 
You can set filters to say what parameters get recorded when recording things, so what you are describing is what a filter could do. 
 
They are applied by pressing the FIlter button in the CIA. 
 
To remove them all the manual says 
 
To remove all filters at once: 
 
Press and hold [Filters]. The parameter buttons change to display filter selection. 
{Clear Filters} appears in the upper left corner of the parameter buttons. 
Press {Clear Filters}. Any applied filters will be removed and the highlights will turn off. 
Release [Filters]. The buttons return to their normal appearance. All parameters are now available to record functions.