Fixture Request, Chinese off brand double sided moving heard EOS profile

Your very unlikely to find a profile for that but its not too hard to create although unless you are using 2.7 beta you'll need to split it into 2 fixtures.

Your biggest challenge is that often the sheet included with these chinese non branded units doesn't match the actual version of software in them - and sometimes even more challenging is when you have two identically marked units but they have different software in them.

But if you build the simple profile for it its usually possible to figure out what the channels in the device actually are. Start simple and test as you go ie patch just the pan and tilt and see if they actually work, or even just patch 21 dimmers so you can control each channel and see what it actually does.

Do you happen to have a full manual you could share? One would be needed for us to make a more permanent profile we can drop into a future patch.

Thank you,

Thanks,
I will get you the full manual pdf tonight. I will also make sure that the manual is correct (channel actually does what it says it does).

Thanks
Samuel

Thanks again,
I have the full manual is at the link below. Just so you know (I also wrote the issue on the manual) In 21 CH mode CH 5 and 6 are flipped and in 15 CH mode 3 and 4 are flipped.

Manual:
https://imgur.com/a/GfovNi2

Thanks again

Samuel

Thank you, Samuel. I have submitted your request.

Thank you

Do you by any chance have an ETA for when it may be ready.

Thanks
Samuel

Hello, Samuel:

This is completed and is in build 74 of the library for v2.7.0 (patch available here www.etcconnect.com/.../Software.aspx)

Thank you,

Thanks!