Options
Related

Hog4 to eNode 8

So, i have a hedge hog 4 that i am trying to connect to my enode8 to expand universes. Im running ethernet from the console to the node, IP and Submask addresses are set in parallel to eachother and the hog shows the additional 2 universes (total of 4 now) but i still dont have any signal to my fixtures from the node. if i connect to the console via universe 1 or 2 i have control. Any suggestions?

I have a feeling its a setting in the console itself, but im just shooting in the dark on this one.

Thanks
Parents
  • 0
    Michael, yes, thats exactly what it is.

    here is what tech support told me:

    enter Network

    under DMX processes enter the settings.

    then under FixtureNet verify the IP address and SubNet Mask. (making the eNode slightly different IP address, and same SubNet Mask)

    Under Art-Net Output, highlight the appropriate universes and verify their IP addresses. (mine happen to be 255.255.255.255)

    I had it working by a fluke... then my boss touched it, and now I'm back to square one. :/
Reply
  • 0
    Michael, yes, thats exactly what it is.

    here is what tech support told me:

    enter Network

    under DMX processes enter the settings.

    then under FixtureNet verify the IP address and SubNet Mask. (making the eNode slightly different IP address, and same SubNet Mask)

    Under Art-Net Output, highlight the appropriate universes and verify their IP addresses. (mine happen to be 255.255.255.255)

    I had it working by a fluke... then my boss touched it, and now I'm back to square one. :/
Children
No Data

www.etcconnect.com