Hog 4 OSC TCP/IP

Hello,
I am looking to control Hog 4 OSC through TCP connection. It works fine with a UDP connection but when I enable TCP I get a connection (and MIDI Viewer shows the connection) But no OSC commands are coming through. Exact same setup except I'm sending the OSC packet down TCP instead of UDP. Anyone actually use OSC with TCP?

Parents

0 morte615 - Former HES Forum Member over 5 years ago

Using HOG 4 PC hardwired (in the same switch actually).
Did you have to do anything different to the OSC packets between UDP and TCP?
I am using the exact same script just changing from a UDP send to TCP send so everything beside the transport protocol should be the exact same.
Midi Viewer shows the TCP connection, and when sent with UDP it shows the commands come in but with TCP I don't see any commands show up in Midi Viewer after it's connected.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 morte615 - Former HES Forum Member over 5 years ago

Using HOG 4 PC hardwired (in the same switch actually).
Did you have to do anything different to the OSC packets between UDP and TCP?
I am using the exact same script just changing from a UDP send to TCP send so everything beside the transport protocol should be the exact same.
Midi Viewer shows the TCP connection, and when sent with UDP it shows the commands come in but with TCP I don't see any commands show up in Midi Viewer after it's connected.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data