Hi there,
Doing some 2.0 tests on my Hog4pc with Lightconverse before I get at\upgrade our RH4
First of all, had some serious connectivity problems with HogConnect and it not connecting to the virtual DP, i fixed this by going back to the V 1.2.1 of hog connect and it instantly connected
As for the effects engine, first of all I love the start,end,direction abilities!
Playing around I noticed some problems though, if I selected my rate(s) then pressed [set] and entered a value of 0 the fixtures stopped as they should, but if I then selected the 0 rate(s) and [set] then a value above 0 after I pressed [enter] the value stays at zero, BUT , if I used the rate encoder wheel the value would increase.
Also if I select any table, press [set] then Off, then [enter] the table value reads "off" but the effect is still running in the output and programmer, except neither displays show the effects symbol. Only that the values are increasing and decreasing as if I never selected "off" in the first place.
This might also be related but I was creating a effect palette that was a pan and tilt at table "off" (so as to stop any active movement effects) but when I click on it, the active pan and tilt tables remain on their original value. Yet if i create to effect palettes where one is set to "sine" and the other "tangent" the tables change without any problem.
Cheers
