Roadhog 4 with DP2000?

Hello

Im not that good at hog yet so im sorry if this is a stupid question

I have an Roadhog 4 and a DP2000 how do i get this to work if it even can work?

Sorry for the bad english
Best redards,
Lauritz

0 marc lorenz over 11 years ago

Hey Lauritz

DP2000 must have software 3.1.9 installed. Then set it into Artnet-Mode and connect it to the fixture-link network and configure it as a normal artnet-node

DP2000 is not direct supported via HOG-Net. Only the DP8000 will work via HOG-net
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 my name is questionmark questionmark - Former HES Forum Member over 11 years ago

Okay, that sounds good.
But where do i get the DP2000 software update?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 my name is questionmark questionmark - Former HES Forum Member over 11 years ago

You connect it to a HogPC and under network you press "Software update" right?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 marc lorenz over 11 years ago

Yes... But you must use a Hog 3 version:
www.highend.com/support/controllers/h3_archive.asp

Version 3.1.9 is the one you need to have
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel