• State Not Answered
  • Date
    lydia - Former HES Forum Member
  • Date
  • Replies 18 replies
  • Subscribers 10 subscribers
  • Views 3583 views
  • Users 0 members are here
Options
Related

Light Converse - Lightconverse - Hog Connectivity Application doesn't launch

Hello everyone!

I’m trying to connect Hog4PC direct to Lightconverse on the same machine without success.

I downloaded the Connectivity Application (www.flyingpig.com/support/hog3/downloads/VisualizerConnectivity.shtml.foo) and followed the guide (lightconverse.net/lc/download/lightconverse_hog3%20direct%20connection%20guide.pdf) carefully.

The guide says on the first page: „2. As LIGHTCONVERSE opens, a Wholehog DP dialog box will open at the bottom right of your computer screen and a Hog icon will be placed in the Windows task bar„. But this isn’t the case.

I tried different versions of the Visualizer Connectivity tool, uninstalled it and installed it again. I’m using Windows 8.1.

I think the main problem is, that the previous installed Lightconverse (Net-In Version with dongle, installed months before Hog4PC), doesn’t launch this Connectivity tool. It’s another version of Lightconverse, then the one shipped as accessory to the hog consoles, but it supports HOG-Net (fixtures are patched on HOG-Net).

Does anyone have an idea or any experience with this problem?

Thanks in advance!

Best,
Lydia
Parents
  • 0
    Hi everyone,
    I haven been using the visualiser for a while. Had just tried using the visualiser with version 3.3.1 yesterday using the fixture net port as mentioned in the manual.
    It seems that the visualiser take in any HogNet data stream even though the visualiser is detected on the Hog4..
    I swapped the input to ArtNet and it instantaneous work.
    Is LC still suppose to work with HogNet input through the FixtureNet port or it is simply the case where it is just ArtNet after version 3.2?
Reply
  • 0
    Hi everyone,
    I haven been using the visualiser for a while. Had just tried using the visualiser with version 3.3.1 yesterday using the fixture net port as mentioned in the manual.
    It seems that the visualiser take in any HogNet data stream even though the visualiser is detected on the Hog4..
    I swapped the input to ArtNet and it instantaneous work.
    Is LC still suppose to work with HogNet input through the FixtureNet port or it is simply the case where it is just ArtNet after version 3.2?
Children
No Data

www.etcconnect.com