I'm trying to get started with learning Hog consoles (as an EOS programmer/designer), I wanted to use the capture demo project to get started, but cannot seem to get the artnet or sacn control to work. I'm also new to capture, so it could be a problem on that end. Capture does show a CITP handshake, but no output control.
The visualizer was auto-detected by Hog, and I went into it and selected the auto detected IP address. When that didn't work, I went to the output page and added Sacn mapping as suggested in the ETC Hog learning series. I went back to capture and saw that Sacn was not detected.
As a complete beginner, what are some next steps I should try? Would love to get started with learning Hog.