Options

Visualiser not working

So far I have been using Light covers to make my training more efficient. Unfortunately
after installing the new version on both PC and RH4, I am not able to get LC working. Then I tries with Show designer that was working perfectly with 3.1 ... .also same thing!
Parents
  • 0
    Hi
    I try to connect RH ver.3.2.0 to Wyg R35 on a W10 PC… but have some problems…
    I use fixture net “optain an IP adr.” and a Linksys router with Cat5.
    Now I connect to Wyg R35 all my fixture light up but I can`t do anything…!
    Did I have to connect the Artnet output even though I use optain an IP adr. …?
    Yes I have read the manual many times… but cannot find the issue…
    Jacob
Reply
  • 0
    Hi
    I try to connect RH ver.3.2.0 to Wyg R35 on a W10 PC… but have some problems…
    I use fixture net “optain an IP adr.” and a Linksys router with Cat5.
    Now I connect to Wyg R35 all my fixture light up but I can`t do anything…!
    Did I have to connect the Artnet output even though I use optain an IP adr. …?
    Yes I have read the manual many times… but cannot find the issue…
    Jacob
Children
No Data

www.etcconnect.com