How do you get channels out of capture?

I used to run boards years ago, but I have not run one (or thought about it) in a very long time. I am working at a school with an Express 24/48. They have it set up with a dimmer per channel. When I do anything in stage it captures the channel. How do I get it to release the channel? I have been looking through the manual and have not found anything.

It is also not running the cues I set up. I am assuming it is because the channels are captured. I have a show soon so I need to figure this out.

Thanks.

Parents

ehuber over 14 years ago

there should be a button lablerd "release" or "REL"...it to has been a while since i touched an express. BUt as i reall it is on the lower right hand side of the console near the number pad.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
newcj over 14 years ago in reply to ehuber

Thanks! That seemed to work, though I did not get much time to play yet and make sure the cues are working.

It seemed logical once you said it. Geez, I even used the word release in my question. :-D
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

newcj over 14 years ago in reply to ehuber

Thanks! That seemed to work, though I did not get much time to play yet and make sure the cues are working.

It seemed logical once you said it. Geez, I even used the word release in my question. :-D
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data