We just had an unusual problem with our Obsession II. We have a two processor tracking back up system. The issue arose when both processors tried to be the primary. An error displayed saying that the system was set to have one primary processor and the other should be set to a backup. We resolved the problem by doing a hard restart.
We were doing a couple of things when this happened. The board-op had just taken control. (We use an RFU set to user 2 for notes) Also I had just disconnected and reconnected an unresponsive 2 port node. (The node is still not responding. It's stuck at the start up screen looking for the network. I haven't had a chance to fix this yet.)
Has anyone else seen anything like this?
We're only in rehearsals at this point so I'll wait until we're out of the weekend to call tech support but I'm curious if this seems indicative of anything to anyone.
Thanks,
Mat